TechnoNICOL hardware

The surface of the roof is continuously exposed to wind, which results in static pressure swings from positive to negative and eventually causes the roofing system to tear off. To increase the reliability of the roofing system, special attention should be given to the constructive solutions of connecting nodes and the quality of the hardware units used, to ensure that all the components of the system work properly and withstand loads over the entire service life, established for the building as a whole. TechnoNICOL offers the following hardware components.

The galvanized steel strip has an anticorrosion coating, which helps it to retain its aesthetic appearance. It has enhanced resistance to torsion and bending.

Perforated tape for areas adjacent to pipes and passages

Type ___ supports with a height of 15 mm and 20 mm create a gap between the tile and the waterproofing coating, which provides for a smooth and rapid removal of water from the surface of the roof.

TechnoNICOL support stand for tiles

A convenient support for the gap between the tile and the waterproofing layer. This makes it possible to remove excess water from the surface of the roof quickly and easily. The supports are highly resistant to weathering and UV radiation.

Round plate-shaped holder TN Ø 50

The plate-shaped holder distributes the load on the membrane to any base. The well-considered geometry of the washer provides it with stiffness and protects the membrane from deformation under the washer. So, if you use such a holder, your membrane will be reliably secured, and you can be confident of the integrity of the membrane, and, therefore, of the roof.

Drill for concrete

The bore bit is designed for unreinforced and reinforced concrete.

TechnoNICOL anchor element

A polyamide anchor shield as a part of the fixing element set when placing a screed on the structure of the layer for mechanical fixing.